3200mAh 3.7V Li-ion Polymer Replacement Battery for Anbernic RG353VS RG 353VS Vertical Handheld Console

Description

Battery model: For Anbernic RG353VS
Capacity: 3200mAh
Rated voltage: 3.7V
Charge limit voltage: 4.2V
Battery type: Li-ion Polymer (Grade A cells)
Compatible with: Anbernic RG353VS, Anbernic RG 353VS
Package include: 1 x battery
Get back to marathon gaming sessions with this high-quality 3200mAh Li-ion Polymer replacement battery, designed specifically for the Anbernic RG353VS handheld console. The RG353VS is distinguished by its classic vertical Game Boy-style form factor, featuring a 3.5-inch IPS screen (640×480 resolution) and a Rockchip RK3566 chipset. Unlike the horizontal RG353 series, the RG353VS’s vertical shell has very specific internal dimensions — this battery matches the original cell’s size and uses the correct small 2‑pin micro connector, ensuring a proper fit without backplate bulging or connector stress.
Technical Details for RG353VS Owners: The RG353VS runs on a Rockchip RK3566 processor and supports dual-boot Linux (JELOS, ArkOS) and Android 12. This 3200mAh replacement battery for Anbernic RG353VS maintains the original 4.2V charge termination voltage and uses low‑resistance cells to ensure stable power delivery during emulation. The built-in protection circuit module (PCM) guards against over‑charge, over‑discharge, short circuit, and over‑current. CE, RoHS, and UN38.3 certified for safety. For best longevity, avoid frequently draining the battery below 10% — lithium-ion cells prefer partial discharges.
Step‑by‑Step Installation Guide for Vertical Shell: 1) Power off the device and remove the four small Phillips screws on the back of the RG353VS (use a PH00 screwdriver). The RG353VS has a vertical battery compartment located behind the lower section of the backplate. 2) Gently separate the backplate starting from the bottom edge — the vertical shell uses plastic clips along the sides, so pry carefully with a plastic spudger. 3) The battery is connected to the motherboard by a small 2‑pin connector. 4) Use a plastic spudger to lift the original battery (it is lightly adhered). 5) Disconnect the old battery’s connector by pulling the plug (not the wires). 6) Connect the new battery — the connector is keyed and only fits one way; do not force it. 7) Place the new 3200mAh battery in the compartment, ensuring no wires are pinched, then reassemble the backplate. 8) If the device doesn’t power on after battery replacement, leave it connected to a 5V/2A charger for 10‑15 minutes to activate the protection circuit.
Compatibility Note: Fits Anbernic RG353VS and RG 353VS only — not compatible with the RG353V (which has dual boot with touchscreen and Android), RG353M (metal shell), RG353P (SNES-style horizontal), RG351 series, or RG35XX series. The RG353VS is distinguished by its vertical Game Boy-style form factor, 3.5-inch IPS screen, and Linux-only operating system (no Android, no touchscreen). Before ordering, please open the back panel to confirm your battery’s connector type. If your RG353VS shuts down unexpectedly when the battery indicator still shows charge, or if it drains too quickly during PS1 or N64 gaming, this 3200mAh replacement battery for Anbernic RG353VS will restore stable power delivery.
Battery Care for Vertical Handhelds: For maximum lifespan, keep battery level between 20% and 80% for daily use. Do not use Quick Charge (QC) or Power Delivery (PD) fast chargers — only use a standard 5V/2A charger. The RG353VS’s charging circuit is not designed for fast charging protocols. If storing the device for more than 2 months, keep the battery at approximately 60% charge. Avoid leaving the RG353VS in hot environments (e.g., inside a car in summer) — heat accelerates battery degradation. Stop using immediately if the battery shows any swelling. For optimal Anbernic RG353VS battery life, perform a full discharge-recharge cycle (drain until auto-shutoff, then charge uninterrupted to 100%) after installing a new battery to help the Linux system calibrate battery level reporting.